1994 Ford f250

ON CERTAIN TRUCKS EQUIPPED WITH SPEED CONTROL, GASOLINE OR NATURAL GAS ENGINES, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT.

Fix: DEALERS WILL INSTALL A FUSED WIRING HARNESS INTO THE SPEED CONTROL SYSTEM FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 7, 2006. OWNERS MAY CONTACT FORD AT 1-866-436-7332. (NOTE: ALSO SEE RECALLS 05V017 AND 05V388)

CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Fix: CK MOTORSPORT WILL NOTIFY OWNERS AND REPLACE THE NONCOMPLIANT LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 1, 2006. OWNERS MAY CONTACT CK MOTORSPORT AT 1-909-610-7211.

ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH SPEED CONTROL, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT, SMOKE, OR BURN.

Fix: BY LETTER DATED SEPTEMBER 12, 2005, OWNERS WERE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED CONTROL DEACTIVATION SWITCH DISCONNECTED. OWNERS WHO HAVE HAD THEIR SPEED CONTROL DEACTIVATED ARE BEING NOTIFIED THAT PARTS WILL BE AVAILABLE AND ADVISED TO MAKE AN APPOINTMENT TO …

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. EQUIPMENT DESCRIPTION: FORD IS REPLACING ALL FIRESTONE WILDERNESS AT 15, 16, AND 17 INCH TIRES MOUNTED ON FORD TRUCKS AND SUVS. FORD REPORTS TREAD SEPARATION CAN OCCUR DUE TO A COMBINATION OF THE SENSITIVITY OF THE TIRE DESIGN TO STRESS, AGING, AND MANUFACTURING DIFFERENCES BETWEEN PLANTS…

Fix: THE REPLACEMENT/REIMBURSEMENT PROGRAM FOR THIS CAMPAIGN EXPIRED ON MARCH 31, 2002. HOWEVER, CUSTOMERS CAN CONTACT FORD AT 1-877-917-3673 OR GO ON-LINE TO WWW.FORD.COM FOR POSSIBLE ASSISTANCE.

THE WIRE HARNESS FOR THE POWER LUMBAR FEATURE ON THE SEAT IS UNDERNEATH THE FRONT SEAT CUSHION SUPPORT WIRES. THE SUPPORT WIRES ON THE DRIVER SEAT CAN CONTACT AND DAMAGE THE INSULATION HARNESS RESULTING IN A HIGH RESISTANCE ELECTRICAL SHORT THROUGH THE SUPPORT WIRES.

Fix: DEALERS WILL INSPECT THE SEATS ON THE AFFECTED VEHICLES. IF NO DAMAGE IS FOUND, THE DRIVER SEAT WIRE HARNESS WILL BE COVERED WITH A PROTECTIVE CONVOLUTE TUBING, WRAPPED WITH ELECTRICAL TAPE AND THE HARNESS WILL BE REROUTED. IF DAMAGE IS FOUND, THE WIRE HARNESS WILL BE REPLACED.

THE PARKING BRAKE CONTROL SELF-ADJUST PAWL DOES NOT LINE UP PROPERLY WITH THE SELF-ADJUST RACHET CAUSING THE PAWL TO SLIP OVER ONE OR MORE TEETH IN THE RACHET.

Fix: A WEDGE WILL BE INSTALLED WHICH WILL SERVE TO LOCK THE PARKING BRAKE SELF-ADJUST MECHANISM PAWL INTO ENGAGEMENT WITH THE RACHET. ALSO, OWNERS WILL BE ADVISED TO RELEASE AND REAPPLY THE PARKING BRAKE WHENEVER TOOTH SKIP OCCURS AND WILL BE REMINDED TO ALWAYS TURN OFF THE ENGINE AND LEAVE THE VEHICLE …

IN A HEAVILY LOADED VEHICLE, WHILE IN THE CRUISE CONTROL MODE, THE THROTTLE MAY NOT REDUCE IMMEDIATELY WHEN THE LOAD ON THE ENGINE IS DECREASED (SUCH AS WHEN THE VEHICLE CRESTS A HILL.) THIS CAN RESULT IN INCREASED VEHICLE SPEED WITHOUT PRIOR WARNING.

Fix: DEALERS WILL REPLACE THE ELECTRONIC ENGINE CONTROL MODULE.

THE U-CLIP STYLE NUTS THAT RETAIN THE FRONT BUMPERS TO THE FRONT BUMPER INNER ARMS CAN FRACTURE.

Fix: INSPECTION AND REPLACEMENT OF THE FOUR U-CLIP NUTS AND THE ASSOCIATED BOLTS.

THESE VEHICLES WERE BUILT WITH NONFUNCTIONAL AIR BAG DIAGNOSTIC MODULES INTENDED FOR CERTAIN VEHICLES OVER 8,500 BLS. GVWR.

Fix: DEALERS WILL INSPECT THESE VEHICLES AND, IF NECESSARY, INSTALL THE CORRECT AIR BAG DIAGNOSTIC MODULE.

THE DESIGN OF THE AIR BAG DIAGNOSTIC MONITOR CAUSES THE DRIVER'S SIDE AIR BAG TO DEPLOY WHEN THE PASSENGER DOOR IS SLAMMED WHILE THE IGNITION KEY IS TURNED TO THE START POSITION.

Fix: INSTALL A REDESIGNED AIR BAG DIAGNOSTIC MONITOR.